Aleene's® Glass and Bead Adhesive™
email to a friend print this page

How to use Aleene's® Glass and Bead Adhesive™


For best results, test small area before use.

1. Thoroughly clean and dry surfaces, including decorative elements, making sure they are free of oil and grease.

2. Apply a small amount of adhesive to the surface and to the decorative element. To ensure a maximum-strength bond, let adhesive set approximately 1-2 minutes before joining surfaces.

3. Position decorative element in adhesive on surface. For rounded surfaces, it may be necessary to tape decorative elements in place until dry to prevent sliding.

4. Sets in 10-15 minutes to support light items. Bond is full strength after 24 hours.


Tips & Techniques


Not intended for plastics. May affect the appearance of plastic rhinestones. Danger: Harmful or fatal if swallowed. Contact a physician immediately. Vapor harmful. Use with adequate ventilation. Flammable. Contains Ethylbenzene, Xylene and Petroleum Naphtha. Keep away from heat, sparks and open flames. Store in cool place, away from sources of heat. Avoid contact with skin or eyes. First aid: Obtain fresh air. In case of contact with eyes, flush eyes with water for 15 minutes. If swallowed, contact physician immediately. Wash skin with soap and water. For further health information, contact your local poison control center. KEEP OUT OF REACH OF CHILDREN.