Little Black Dress Apron Little Black Dress Apron Little Black Dress Apron
Photos:

Materials List

Little Black Dress Apron


You have your little black dress for an evening out … Now you can have one for the kitchen too! With a little help from Aleene’s® Fabric Fusion™, you can create this chic Little Black Dress Apron in less time than it takes to whip up your favorite meal! Aleene’s® Fabric Fusion™ is formulated to quickly and permanently bond a variety of fabrics and embellishments so you can spend time doing more important things … like serving your family in style!


Project Rating:
Rates: 2 Avg: 5
(sign in to rate projects)


Share:
Share
Email
Print

Instructions

  1. Purchase or sew a bib apron.
  2. Protect work surface with a plastic bag or paper.
  3. Draw a chalk or pencil line 17" from the top of the apron across the lower part of the apron.  This will be the guideline for attaching the printed fabric.
  4. Cut a piece of the fabric about 16" high and 4" wider than the width of the lower area of the apron. Fold 1" under on one side and press. Lay the pressed edge along the line on the apron and make sure it fits across and beyond each side about 2". Using Fabric Fusion, apply glue to the apron along the pencil line and 1" below. A brush may be used to spread the glue so there are no thick areas.  NOTE: Use masking tape to hold down glued areas until they are dry.
  5. Carefully turn the apron over and on each side fold under 1” and once more to make it the same width of the apron. Sparingly use the glue to hold in place. NOTE: If the lower edge or sides of the apron are too long or wide for the printed fabric, trim them as desired before gluing the sides down.
  6. Press and hem the bottom of the printed fabric to desired length using glue as before. Let dry.
  7. At the top of the bib area, cut off the neck strap.  Determine length of ribbon needed to become new neck strap. Lay the apron out flat. Glue two strips of ribbon next to each other from one side to the other on the back side. Hold in place with masking tape. NOTE: Thick grosgrain ribbon is best.
  8. Just above the printed fabric, sparingly apply glue and place two rows of ribbon. Glue ends of ribbon to the back side of the apron. Make a bow and glue to the ribbon.
  9. Lay all the chains and charms out on the bib area before cutting any chain lengths. When a pleasing design is achieved, attach the charms to the chain with jump rings. Lay all of the chains on the bib again when finished and then cut the excess chain off with wire cutters. Starting at the top outside chain, and using the Fabric Fusion pen, apply a tiny bead of glue along the chain links and press onto the fabric. Use masking tape to hold in place. It is not necessary to glue each link down. Glue down the charms that are larger and the ones with the flat backs. Now glue the charm or jewelry piece to the ribbons on one side of the bib. Lay flat until dry.

 

 

 

#ad08_018

Miscellaneous Notes


The chains should have a flat area for gluing to the fabric. Charms that are flat on the back are best also. Different finishes, antiqued, shiny or dull, make an interesting combination. The charms can be all one design, hearts, crosses, keys, etc, or any combination desired. The center charm

Project Comments

view all comments
Sorry. No comments found for this project.